I was commissioned to HueForge Spock, and with permission have been allowed to share this with the public!
While this isn't my usual 'blendy' prints, this came out really nice and took just under 3 hours! I have included the 3MF file for Bambu Studio users, as well as the STL file for non-Bambu users.
If you use the STL, please follow the instructions below:
Print Instructions Print at 100% infill with a layer height of 0.08mm with a base layer of 0.2mm
Filaments Used:
- PLA Kingroon Black Transmission Distance: 0.1
- PLA+ Overture Dark Blue Transmission Distance: 4
- PLA TECOR Light Blue Transmission Distance: 3.5
- PLA BambuLab Tough Vermilion Red Transmission Distance: 3
- PLA CC3D Lemon Yellow Transmission Distance: 6.8
- PLA TECOR Beige Transmission Distance: 6.3
This print uses 6 unique filaments
Swap Instructions:
- Start with Black
- At layer #6 (0.6mm) swap to Dark Blue
- At layer #8 (0.76mm) swap to Light Blue
- At layer #10 (0.92mm) swap to Vermilion Red
- At layer #14 (1.24mm) swap to Lemon Yellow
- At layer #16 (1.4mm) swap to Beige for the rest.
If you'd like my work and would like to support me, you can now subscribe to a Thangs membership plan!
Joining will give you a commercial license to sell the physical prints of my models, access to a private discord, all paid models, and early access to selected models!