Skeleton Playing Guitar - Halloween Greeting Card

Happy Halloween!

Give your favourite musician a creepy Halloween card to show them how much you appreciate their Hellish music! This is a print in place Halloween card, with very little post processing involved.

I used Hueforge to determine the layer swaps from the base image, and have reproduced the instructions below.

Post Processing Instructions:

Once printed, you will need to have a lighter, or a blowtorch to heat up the middle seam (it's the thin one down the middle of the print) to make the card ‘foldable’. Once you've heated it up enough, you will be able to fold it into a card. Do it slowly, and bit by bit so it doesn't accidentally warp other areas of the card.

Options:

I have provided the STLs and alternative profiles for both the card as well as JUST the Halloween image, if you're not interested in the card format. Both instructions for the hueforge print are exactly the same.

The STLS are named 'HellMusic_Card' for the card STL, and 'HellMusic_Print' for just the print.

If you are using a Bambu Lab printer, with an AMS, I have included the 3MF.

Print Instructions (For both Card and Print):

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:

• PLA Kingroon Black Transmission Distance: 0.4

• PLA CC3D Orange Transmission Distance: 7.4

• PLA Sunlu Beige Transmission Distance: 8.2

• PLA Kingroon White Transmission Distance: 8

Swap Instructions:

• Start with Black

• At layer #9 (0.8mm) swap to Orange

• At layer #13 (1.12mm) swap to Beige

• At layer #21 (1.76mm) swap to White for the rest.