The CAT-erpillar went down really well, so here's it's long lost cursed cousin - the Quackapillar!

Half duck, half caterpillar, full cursed :P

This prints really well, with very minimal supports. If you use the 3MF file with Bambu Studio, my settings should already be applied. If you don't use Bambu Studio, here are the recommended settings instead:

Print Recommendations: Layer height: 0.16mm Walls: 3 Top surface: concentric Infill: 8% Cross hatch Supports: Yes, tree organic, 0.25mm Z distance, 0 interface layers