Oversized Eevee Pokemon Card - HueForge Hybrid Print

Yes, I know, my painting skills are severely lacking LOL!

This Eevee model has been one of the most requested cards, and I finally had the time to get around to it! Much like the other oversized cards, this is a HueForge Hybrid, combining a 3D model and a HueForge filament painting into a single model.

No supports are needed for this print and no gluing is required. However, you will need to paint the Eevee once the the print is finished. If you want to resize this print, please ONLY resize the X and Y dimensions and NOT the Z dimension.

If you are using Bambu Studio, the included 3MF file will have the colour swaps and height range modifiers already loaded within the file. All you need to do is make sure your AMS is loaded with the correct colours. You DO NOT need an AMS for this print, and if you do not use one, just use a pause instead of a filament swap so that you can manually swap your colours.

If you ARE NOT using Bambu Studio, you can download the STL file and follow the instructions below:

Print Instructions:

• For layers 0.00mm to 2.28mm print at 100% infill with a layer height of 0.08mm with a base layer of 0.2mm. This is the 'Card' portion of the print.
• For layers 2.28mm to 4.28mm print at 0.16mm, 4 walls, 3 tops, 3 bottoms and 8% Gyroid infill. This is the Eevee portion of this print.
• In order to use these different settings on different layers, you can use a 'height range modifier' in the slicer to set them.

You will notice in the 3MF file that I have also added a height range modifier for 0.00 - 0.6mm printing at layer height 0.2mm. This is completely optional, I just do it to make the print speed up since its just priting base layers with no blending requirements. You do not have to do this if you do not want to.

Filaments Used:

• PLA BambuLab Basic Red Transmission Distance: 5
• PLA Kingroon Black Transmission Distance: 0.1
• PLA Chrominal Penumbra Gray Transmission Distance: 6.9
• PLA BambuLab Basic Jade White Transmission Distance: 5.8
• PLA CC3D Lemon Yellow Transmission Distance: 6.8
• PLA Sunlu Coffee Transmission Distance: 1.8

This print uses 6 unique filaments

Swap Instructions:

• Start with Red
• At 0.68mm swap to Black
• At 1mm swap to Penumbra Gray
• At 1.16mm swap to Jade White
• At 1.8mm swap to Lemon Yellow
• At 2.44mm swap to Coffee for the rest.

This print uses this Eevee model by Irkman . They have a bunch of Eevee's evolutions available as well so definitely check them out!

If you'd like my work and would like to support me, you can now subscribe to a Thangs membership plan!

Joining will give you access to a private discord, all paid models, early access to some models as well as a commercial license to sell the physical prints of my models.