This is a print that looks like it's an embroidered piece. Seeing the print physically in real life is mind bending, knowing that it's completely 3D printed and not a single strand of yarn was used for this.
The 3MF file will have all instructions for Bambu Studio/Bambu printers included. If you do not want to use the 3MF please use the included STL file and the following instructions:
Print Instructions Print at 100% infill with a layer height of 0.08mm with a base layer of 0.20mm
Filaments Used:
- PLA BambuLab Matte Charcoal Transmission Distance: 0.6
- PLA CC3D Orange Transmission Distance: 7.4
- PLA CC3D Lemon Yellow Transmission Distance: 8
- PLA Sunlu Beige Transmission Distance: 8.2
- PLA BambuLab Basic Jade White Transmission Distance: 5
Swap Instructions:
- Start with Charcoal
- At layer #8 (0.76mm) swap to Orange
- At layer #13 (1.16mm) swap to Lemon Yellow
- At layer #16 (1.40mm) swap to Beige
- At layer #17 (1.48mm) swap to Jade White for the rest.
If you'd like to support me, I now have a Patreon!
Joining will give you behind the scenes information on WIPs, access to a private discord, early access AND exclusive models!
If you want to sell any physical models I have uploaded anywhere, an unrestricted commercial license is available on the $10AUD tier of my Patreon!