Sen | Planters

Sen is a family of 3D printable planters for indoor or outdoor use for your plants.

You can use them directly as planters or insert standard plastic pots as their sizes allow for the incorporation of these sizes of planters:

● 1: 10.5 cm diameter x 9 cm high. ● 2: 12 cm diameter x 11 cm high. ● 3: 14 cm diameter x 13 cm height.

Each size also has a matching base to prevent possible water leaks. So you can water your plants with peace of mind :)

3D PRINTING PARAMETERS For the body (sen) you have to set the following parameters in the cutting program (I used Cura):

Filling: 0% No support No adhesion Layer height: 0.2 mm Top layers: 0 Bottom layers: 5 (minimum) Wall line count 3 (minimum) Nozzle size: 0.4 mm Nozzle temperature: 200ºC Shrinkage: Yes *To increase the tightness Increase the number of walls, decrease the printing speed and increase the layer height. **You can also try the vase mode if you have a larger nozzle (>0.4mm), increasing the temperature (+5ºC) and decreasing the printing speed (<30 mm/s).

For the matching base (arcsen) you should print without using the vase mode following these parameters:

Filling > 20%. No support No adhesion Layer height: 0.2 mm Top layers 4 Bottom layers 4 Number of wall lines 3 Nozzle size: 0.4 mm Nozzle temperature: 200ºC Shrinkage: Yes *To increase tightness Increase the number of walls, decrease the printing speed and increase the layer height.