The minecraft frame requires FOUR 12x3 magnets (you can find them on Amazon). The 4 colors used are in the following order

1. Sunlu PLA Brown
2. Elegoo PLA Marble Brick Red
3. Overture PLA Matte Light Brown
4. Duramic PLA+ Light Brown

The following print settings are a must:

• 0.2mm layer height (necessary for the pauses)
• 2 shells/perimeters (can be increased if you want to use more filament)
• 4 top surfaces
• 8% infill
• slow down top layer to around 60-80mm/s
• 15mm Mickey Mouse Ear brim attached at 0mm if you're uncertain about your bed adhesion at the corners
• Colors & Pauses: Start printing with Sunlu Brown Layer 60 (12mm) - switch from Sunlu Brown to Elegoo Marble Brick Red Layer 70 (14mm) - Insert Magnets (use a small drop of superglue to hold the magnets so they don't jump and stick to the extruder) Layer 72 (14.4) - switch from Elegoo Marble Brick Red to Overture Matte Light Brown Layer 124 (24.8mm) - switch from Overture to Duramic Light Brown