These Minecraft boots are printed with following order of filament colors :

1. Elegoo PLA Sparkle Green
2. Elegoo PLA Sparkle Turquoise
3. Sunlu High Speed PLA Mint Green
4. Sunlu High Speed PLA Ice Blue
5. Elegoo PLA White

Each armor pieces requires TWO 12x3 magnets. This particular model doesn't require magnets, but requires the Joiner piece to be printed. This should be printed in Elegoo Marble Brick Red (or whatever color you choose as the second color of the frame), so that it will be blend in with the frame. The Joiner piece is where the magnets are inserted with a pause at layer 19.

The following print settings are a must:

• 0.2mm layer height (necessary for the pauses)
• 2 shells/perimeters (can be increased if you want to use more filament)
• 4 top surfaces
• 15% infill
• slow down top layer to around 60-80mm/s
• 15mm Mickey Mouse Ear brim attached at 0mm if you're uncertain about your bed adhesion at the corners
• Colors & Pauses: Start printing with Elegoo Sparkle Green Layer 57 (11.4mm) - switch to Elegoo Sparkle Turquoise Layer 61 (12.2mm) - switch to Sunlu Mint Green Layer 65 (13mm) - switch to Sunlu Ice Blue Layer 69 (13.8mm) - switch to Elegoo White