Gridfinity | Solder Tip Holder

511 downloads · 4 years ago · Gridfinity holder for your solder tips which are laying around. Two versions: 1x1 - 5 Tip 1x2 - 14

This model is restricted by licensing terms.

View license.

Description

Gridfinity holder for your solder tips which are laying around. Two versions: 1x1 - 5 Tip 1x2 - 14 Tips Allows you to see which tips you have available and spaced far enough apart to allow for easy plucking of your desired tip. Shout out to Zack for his Gridfinity system

Derived from: Gridfinity Divider Bins by Zack Freedman is licensed under CC BY-NC-SA 4.0

Tags:

Community Makes (1)

3D Printed Gridfinity (Solder Holder) by Brian Kerley based on Zack Freedman's design

Community Makes (1)

Discussions

bigbrisco4 years ago

Hey Brian, Thanks for the model, I printed it in transparent green PETG. The toelrances were a bit tight for my hakko tips but I drilled them out a bit and they work fine. Also, did you notice that the magnet holes on the bottom are missing? :)

brian.kerley4 years ago

v2 has been added which should correct these issues

brian.kerley4 years ago

Yeah, they were a bit tight in ABS when I printed initially. I loosened the tolerances afterwards but I probably should loosen them up further.

Regarding the magnet holes, yeah, I accidentally cut those out too. Not new to parametric CAD, but this was my first use of Fusion. I'll try to make a few fixes and re-upload in a couple days