Prusa Official Enclosure Mounts

Some mounts for the Prusa MK3/MK4 enclosure.

Holes are threaded for M3 screws.

• Exterior vertical edge center Raspberry Pi mount
  • Used with this RPi case
• Interior vertical edge center articulating camera arm mount
  • Designed for this articulating arm system
• Rear exhaust port bulkheads
  • 4" duct
  • 6" duct
• Transport handles with threaded hole for PC4-M10 (BSP 1/8" thread) PTFE fitting (for reverse bowden tube)
  • Hole on left side of handle
  • Hole on right side of handle
• HEPA filter housing
  • For use with AROEVE MK01/MK06 filter replacement ($27 for 2)
  • Attach the base on the inside of the exhaust port and attach a 120mm fan on the
  • outside with M3 screws. Then screw on the lid to seal
  • I would use a powerful fan that can handle a lot of static pressure. This ($30) is probably overkill, but it's what I use. I verified negative pressure in the enclosure when the fan is on low

No supports. Printed in PETG.

Uploaded by Thangs Sync