Just a simple bookmark.

There's a regular sized bookmark at 1.25" x 4.125" plus the top tab, and a longer bookmark that's 1.25" x 5.125" plus the top tab. The little tab at the top keeps them from falling into the pages.

They're thin, quick prints. Enjoy!

Simple Bookmark

Simple Bookmark.STL

I just learned how to play Mancala, so I designed my own!

This fully functional design will print on a 210 mm x 210 mm bed.

This is a simple board game, and is a ton of fun to mess around with. Here's a super short video by Triple S Games that explains how to play:

https://www.youtube.com/watch?v=OX7rj93m6o8

I wanted to make my own simple version with bright happy colors, and this is what I came up with! If you want to make your own, you should print:

- 1 Board
- 2 Covers
- 48 Pellets

The Pellets are small, so feel free to print a few extra. The covers should fit snugly on the end cups, allowing you to store the pellets there.

There are small holes on the bottom of the game board for 1/2" rubber feet. These should keep the board from sliding around so much while you play. Here's a link to the ones that I used, but any that are 1/2" should be just fine.

https://www.walmart.com/ip/seort/16782103

Enjoy playing!

Mancala!

Mancala Board.STL

This keychain easily slides together to hold your SD card! It locks itself in place once it is secured on your keychain.

SD Card Locking Keychain

SD Card Keychain Base.STL

This dock mounts all of your Nintendo Switch controller accessories to the back of the Switch Dock itself. It locks itself in when the back cover is closed. The accessories slide easily on and off. Make sure the sliding rails are sanded smooth, or the Joy-Con trigger extensions could get caught on the rough layer lines, making it extremely difficult to remove from the dock.

There is a slight angle along the top to allow a snug fit inside the Nintendo Switch Dock. This means that when printing upside down, I usually leave supports on just so that there will be a layer or two protecting that slight angle. You could probably print this without supports on, but I haven't tried it yet.

Nintendo Switch Accessory Dock

Nintendo_Switch_Dock.STL

A simple 6.5" straight edged drawing tool for drawing straight lines. The shape lends itself to easy tracing and control.

For class, we need to format our homework with straight lines. "Straight edge required", so I designed this in about 7 minutes and printed it in about half an hour.

For fun, I added a few filament changes. Enjoy!

Probably Useless Straight Edge

StraightEdge.STL

Activity related to collaborating with others on models

Likes, comments, and activity from your community

A roundup of models that we think you'll like

For when we think someone might have posted your content as their own

New content from your premium memberships

Emails and messages from designers you follow

benjimerrell13

Achievements

Seedling

Simple Bookmark

Mancala!

SD Card Locking Keychain

Nintendo Switch Accessory Dock

Probably Useless Straight Edge