I wanted to see if I could print a recoil absorbing pad like the Limbsaver I bought out of TPU. So a couple days of designing later and I have these. V1 I based of an airsoft AR stock, V2 I changed it out for a spiky texture, V3 I gave up on textures because a flat surface allows for the most squish.
I have since gotten much better quality printers and gotten better at Fusion. This one is smoothed out and feels better against your shoulder.
The setting that seemed to yield the best results are
10% infill Gyroid
15mm/s
Category:
1 Likes6 DownloadsMarch 25, 2023
1 Likes6 DownloadsMarch 25, 2023