A Deconstructed D6 designed for perspective and function.

I built this from scratch in Autodesk Inventor as a fun project that turned out great. its centre of mass is less than 0.1mm from centre of model so very unlikely to favour one side more than others.

Drawn at 25mm cube it's a bit large in the hand, scale as you wish in your slicer software. I personally printed at 100% infill and its still lightweight. it needed supports for printing, i recommend printing with a number that has no hole to the build plate so no supports are needed/generated in the tiny hole of the number, it was difficult when i had to remove it from the number 6.

My print was using a 0.2mm nozzle on my ender 5 plus. 200c nozzle and 60c bed.