Description This is a 5.5” Mighty Hoop Stabilizer Insert designed to sit inside the hoop and help keep stabilizer/backing more stable during setup/hooping. If you’re tired of stabilizer creeping, wrinkling, or walking around while you’re trying to hoop consistently, this insert acts like a rigid guide/support so the stabilizer stays flatter and more controlled.

What it’s for Stabilizing cutaway / tearaway / no-show mesh while hooping Helping reduce stabilizer shifting while aligning garments Improving repeatability when you’re doing multiple pieces in a run

What it’s NOT It’s not an official Mighty Hoop part (just a helpful shop tool) It won’t fix bad hooping technique, but it does make consistency easier Fit note

Made for the 5.5” Mighty Hoop size. Fit can vary slightly depending on hoop wear and printer tolerances—see print notes below. How to Use (quick steps)

1. Hoop your stabilizer as usual.
2. Place the insert inside the hoop opening.
3. Smooth stabilizer flat against the insert.
4. Proceed with garment alignment/hooping.