Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:5767326.

Countersunk spacer, 10mm in height with an ID appropriate for M6 and 1/4" bolts.

The version I actually printed was a little tight, I edited the ID to have a little more clearance but I have not printed it myself to verify.

Either way, I've also included the f3d file because I'm a communist and I believe in the free sharing of intellectual property for all.

<3

10mm spacer for M6 or 1/4" countersunk bolts

Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:5767036.

My remix of the top mounted Ender 3 tool holder, because what's the point of a tool holder if you dont customize it to your own hyper specific niche needs?

Holds all the tools that come with an Ender 3 V2 plus:

-2x Tweezers
-Feeler Gauge (14 mm x 9 mm)
-Scalpel and spare blades (in packaging)
-A Second Screwdriver
-Vernier Calipers
-3x Micro SD card slots

Also includes a kickstand meant to be used in place of the upper leg presented in this print by 3d4LeyeF 
https://www.thingiverse.com/thing:4715987

NB I have not yet tested the kickstand or printed 3d4LeyeF's model to verify.

The Micro SD slots were a little tight on my print, so I've increased their dimensions a smidge.

Either way, I've included the f3d file for any edits you might wish to make because I'm a communist and I believe in the free sharing of ideas.

<3

Ender 3 V2 Tool Holder (Kenteclaat Remix)

Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:5766166.

Made this remix so I could use M6 nuts and bolts (which I have in abundance) to mount the stock spool holder to the mount and use the T nuts to anchor the mount to the frame.
Also added a second frame mount hole because personally, I believe in using two fasteners rather than one.

Works out well enough, the frame mount holes were a bit tight on the version I printed, It wasn't too difficult to work the bolts through them, but I made edits and reproduced the STL file for you folks.

10mm M6 nuts fit into the two slots in the back and become captured nuts for mounting the stock spool holder, pretty straightforward procedure.

Also included the f3d file because I'm a communist and I believe in the free sharing of intellectual property for all.

<3

Angled Spool Holder Mount (Kenteclaat Remix)

Activity related to collaborating with others on models

Likes, comments, and activity from your community

A roundup of models that we think you'll like

For when we think someone might have posted your content as their own

New content from your premium memberships

Emails and messages from designers you follow

alex.delapenha

Achievements

Seedling

10mm spacer for M6 or 1/4" countersunk bolts

Ender 3 V2 Tool Holder (Kenteclaat Remix)

Angled Spool Holder Mount (Kenteclaat Remix)