soy miembro pero no me deja descargar

Hello I buy this file but I can’t download

Hi, you don't use supports? I've printed one without them but the first layers (where you then add command strips) looks really bad. Is there anything else you change? thanks

Olá, comprei e imprimi, só que a minhas raquetes de padel não entra se nao girar ela 180 graus, só que se eu fixar na parede aí nao tem como entrar a raquete, tem como aumentar um pouco mais o espaço onde fica o cabo da raquete? ou voce recomenda aumentar a peça no geral?

Hey, thanks for printing it!

I don't use supports and the overhang prints fine (the overhang-surface obviously is not highest quality but as it is on the backside and hidden under the command strips anyways, I don't consider it a problem).

However, you can try to use support in this area - that should do the trick :)

Hope that helps - if there are further issues you can reach me on my Discord