tracking pixel
Hachi A

Ring Mailbox Sensor Antenna Mount

by
adachi86
Follow
Follow
Remix Model
adachi86
adachi86
|
Image 1 of 3
Ring Mailbox Sensor Antenna Mount 3d model
adachi86
adachi86
|
Image 1 of 3
Ring Mailbox Sensor Antenna Mount 3d model
2D
3D
Makes
Ring Mailbox Sensor Antenna Mount 3d model
Ring Mailbox Sensor Antenna Mount 3d model
Ring Mailbox Sensor Antenna Mount 3d model

This is a mount for the antenna unit of Ring Mailbox Sensor.

The product comes with a double-sided mounting tape to affix the antenna outside of the mailbox, but it does not work well if it must be mounted to a rough surface of a wooden post. This mount can be screwed on securely on the post, then the antenna can be press-fit into the mount without glue or tape.

I printed it with matte PLA because it was being installed on a north-facing side which would not be directly exposed to the hot summer sun, but more heat-resistant material would be recommended depending on your application.

Note: I designed the screw hole to accept the screw that came with the product: ⌀3 hole with ⌀6x2 countersink.


0 Likes1 DownloadsJuly 19, 2024



0 Likes1 DownloadsJuly 19, 2024