This maze-solving tile will redirect balls away from dead-ends to try and navigate the labyrinth you and your friends have built. It's sort of a combination between the Red Hot Steel Ball Tile and a Flip-Flop.

If the ball that passes through this gets stuck on its path, you rotate the spinner one notch clockwise. This causes the exit path to cycle between left, middle, and right. Use it to protect routes from being blocked off. Or you can change the direction intentionally by blocking the path below or putting in a trap tile.

Rules: Trigger (in spinner): If this ball becomes stuck, rotate the spinner 60 degrees clockwise.

Rules Clarifications:

• The ball is not considered 'stuck' until all pending effects have been resolved. So, for example, this effect does not trigger from a ball stopping in the IN side of a Teleport Tile.
• If one of this tile's exits is blocked and the ball ends up stuck inside this tile, you will still rotate the spinner.
• If the ball gets rolling again after getting stuck then gets stuck again, you don't rotate the spinner a second time.

Required Materials:

• Six M3 x 12mm screws
• One M3 x 6mm screw
• Two M3 washers (optional)
• Two 6mm x 2mm magnets
• Glue

Printing: Print the base with supports.

Assembly:

1. Glue one magnet into each slot on the side of the spinner. Wait for the glue to set.
2. Insert the 6mm screw through the bottom of the base and stack both of the washers on top.
3. Stack the spinner on the screw and screw it in.
4. Screw the 12mm screws into the corners of the base.

If you like this tile, I have a bunch more on my profile!