Zack F

Zack Freedfinity - Gridfinity in Zack's Head

by
ZackFreedman
Follow
Follow
Remix Model
Zack Freedfinity - Gridfinity in Zack's Head 3d model
Zack Freedfinity - Gridfinity in Zack's Head 3d model
2D
3D
Makes
Be the first to upload a Make
This model is restricted by licensing terms. 

Gridfinity began in my head, and it's time to shove it back in. This 3/4 scale stylized scan of my noggin is sized for a Prusa i3 Mk3S+ or other 200mm³ printer, and gives you a whole 2x2x6 units of storage! Whoa nelly!

The source scan was acquired with Polycam on an iPhone 11. I decimated and remeshed it for the low-poly look.

To conserve time and filament, I strongly recommend not printing this at all. It's very silly.

But if you must, pull out every dirty trick in the book. Print 0.6mm lines with your 0.4mm nozzle, turn infill down to the bare minimum, and turn off supports altogether. Don't support the model - support me at https://patreon.com/zackfreedman.

Also, don't scale down the print. That's stupid.

Fusion source file: https://a360.co/3F1HHUK

Gridfinity is the ultimate organizer for your whole workshop! Learn more at https://gridfinity.xyz.

Find more Gridfinity accessories at https://bit.ly/3E2NxnZ

Gridfinity Tips!

All storage blocks are compatible with all baseplates! You can add 6x2mm magnets to the corners! You can also use M3 screws to secure the corners.


38 Likes77 DownloadsDecember 5, 2022



38 Likes77 DownloadsDecember 5, 2022
This model is restricted by licensing terms.