After using my previous model for 6 months I decided to fix some short comings. Namely:

• The screwdrivers were too close together for my fat fingers
• Screwdrivers are vertical and difficult to retrieve, plus mounting multiple rows of screwdrivers was taking up too much space
• Bolt Locked fittings is overkill for this model

Here is an alternate version that mounts the screwdrivers at an angle. Making them far easier to retrieve and replace. I have also reduced the number of holders per 100mm to allow for people with fatter fingers to easily access them. Finally, I switched to PushFit fixtures as I just found the Bolt Locked ones to be too fiddly and unnecessary.

Models Included

• 5 x Holder (PushFit)
• 10 x Holder (PushFit)
• 1 x Holder (PushFit)
• 10 x Holder (BoltLock)

Printing Printed with 3 wall loops. Everything else was defaults. The model includes it's own supports, so just break away the top part of each holder after the print.

Note I used PETG in the photo examples, but they print better in PLA (I'd run out of black PLA 🤦🏻‍♂️)