Coco's Ink Wand Stylus Grip (Apple Pen Gen 1)

A stylus grip based on Coco's ink wand, as seen on the "Witch Hat Atelier" series. For the Apple Pen Gen 1.

All the parts are separated for assembly, no need for a MMU/AMS system!

All the parts are oriented to avoid supports. I recommend printing the body and neck using a brim, to prevent the extruder head from knocking the wand body over at high speeds.

Included are inlays to decorate the diamond and star-shaped pockets on the body. The neck screws into the body of the pen and the rear parts glue on top of the neck. Don't over tighten the neck thread, its not necessary and can damage the threads over time.

Test fitment of the parts, as you may want to sand some of the surfaces before applying adhesive. This can ensure a better bond. Always use PPE when handling harsh chemicals or strong adhesives.

There are 4 diamond shapes that are press fit through the neck section instead of painting. You might need to sand down the sides a bit if they don't fit. One of the diamonds is bigger, this one goes in the slot closest to the threaded end of the neck.