🎨You can find the multicolor version of this model on my Thangs page. https://than.gs/m/1368326

🔔Please add a brim to the connectors, as they are quite small. To increase flexibility, use pliers to gently bend or loosen them before inserting into the hole—instead of relying on the hole itself to provide flexibility. 🔔If the parts don’t fit as expected, feel free to scale them

💰 You can obtain the commercial license for this model by joining my Thangs Membership or Patreon at the Merchant Tier or above.

🔔Ensure glue is applied to the square joint. If the fit isn't right, adjust the scale as needed for your setup.

🔔The keychain model is designed to use a 15mm (diameter 0.8mm) ring.

🔔Printing supports aren’t required, but they may improve the overall quality.

🔔Printing in 0.15mm layer height is recommended.

🔔You may need to perform post-processing on the models, such as smoothing sharp edges and ensuring the separate parts are securely attached for safety.

🔔Add brim or apply glue to the bottom if extra adhesion is needed.

🔔The rendered images are for reference purposes only, and any silver ring shown in the pictures is not included with the model.

❗Please do a test print to ensure quality before starting a mass print.