Just another Retro Rocket Piggy Bank - the concept makes it a remix (from https://www.thingiverse.com/thing:689004 and https://www.thingiverse.com/thing:2714573) but it is an original design from scratch. Anyways.
Different from the orignal designs the closure went to where it belongs (bottom), plus I added some decorative rivets along the rocket body and some additional jets on the tail fins - mainly to give it some surface to stand on while printing.
The Lid (two variations) prints without supports, the rocket body however needs some - but remember to put a support block on the nose and well beneath, otherwise you end up with supports inside the rocket body - and you do not want that.
The model prints just over 20 cm high, to the delight of the future owner of your model the coin slot will accept Swiss 5-Franc coins (and, of course, bills ...)
Enjoy