Panagiotis T
Awarded to:Tsitman
100 All-time make votes
DigitalDigital Store
Bundle
PrintsPrint Store
My Thangs
Access 15,000+ models$14.99/month
DigitalDigital Store
Bundle
PrintsPrint Store
My Thangs
Access 15,000+ models$14.99/month
profile hero image
Tsitman’s profile picture

Tsitman

10 followers0 downloads

BSc IT

Achievements

25 Models downloaded badge
Trailblazer
25 Models downloaded
10 Makes published badge
Amateur Maker
10 Makes published
100 All-time make votes badge
Rising Star
100 All-time make votes
All
Sort by:

Serene Wave Table Lamp

Serene Wave Table Lamp - Use minimum 0.7mm line width, 0 bottom layers, vase mode on - 3d model

Zephyr TableLamp

Zephyr TableLamp - 0.65 line width & 0 bottom shell layers - 3d model

Rippled Mushroom Twisted Lamp

Rippled Mushroom Twisted Lamp - 0.7 line width for shade & vase mode 0.42 line width for base & 2 walls - 3d model

Trio pen Holder

Trio pen Holder - Print the triple-exterior in vase mode with 0 bottom shell layers, use 0.08-0.16mm for layer height and do not increase a lot the line width, use about 0.4-0.5mm. All other parts can be printed normally with basic settings using 1–2 walls (I used 1). Important: The model isn’t well-tuned yet (waiting @Kraken.Decor for exact print instructions) - so check/adjust tolerances before printing, otherwise the two parts won’t fit into each other. - 3d model

Lara Soft Lamp

Lara Soft Lamp - 0.6 line width - 3d model

Halo Table Lamp

Halo Table Lamp - line width: 0.8mm - 3d model

Twist Glow Table Lamp

Twist Glow Table Lamp 3d model

Brisa Lamp

Brisa Lamp 3d model

Twisted Cream

Twisted Cream 3d model

Spiral Flame Lamp

Spiral Flame Lamp 3d model

Lamp Ondula

Lamp Ondula 3d model

Torsion

Torsion 3d model

Drift lamp

Drift lamp 3d model

Sophie Lamp

Sophie Lamp 3d model

Orbe

Orbe 3d model

Lara Lamp

Lara Lamp 3d model

Tide Lampshade

Tide Lampshade 3d model