A stash container modeled after a standard Fire Hydrant (or at least the ones I see here in South Carolina)! This model prints in separate pieces with zero supports required with the individual pieces threading together, and the front cap acting as a lock to hold the inner container in place.

There are 2 different inner containers available:

1. A container with a "secret" compartment underneath, so there are two different storage compartments
2. A container with one large storage compartment.

Printing Info: These are just the settings I used to test the model, feel free to use whatever settings work best for you.

• FDM or Resin: FDM
• Scaling: Scaling up should be fine, clearance might get tight if scaled down too far.
• Supports: None
• Infill/Perimeters: I just used 15% infill with 2 perimeters.
• Nozzle Size: 0.4
• Layer Height: 0.2
• Material: Any

Printing Instructions:

• Choose whether you want the full storage container or the container with the secret compartment.
• Print the container you choose along with the body, front cap, top cap, and 2 side caps.
• Thread pieces together afterwards, installing the container before the front cap. The front cap acts as a lock to hold the container closed.