Balloon Butterfly Magnet

A balloon butterfly magnet.

This print requires 5 round magnets of width 6mm and height 3mm. To install the magnets, put a pauze just before the holes for the magnets are covered up when slicing.

Supports needed when printing. Be careful when removing the supports from the antennas, those are the most fragile part of the model.

ALL The Crafty Maker designs are protected by Copyright Law. By downloading, YOU HAVE NO RIGHT to sell any digital files or reproductions from those files. If you want a commercial license to LEGALLY SELL 3D prints, you'll need a The Crafty Companion subscription.