T

25x75x50 20deg sloped front bin v6.stl

by
Tawpie
Follow
Follow
Remix Model
T
Tawpie
|
Image 4 of 4
25x75x50 20deg sloped front bin v6.stl 3d model
T
Tawpie
|
Image 4 of 4
25x75x50 20deg sloped front bin v6.stl 3d model
2D
3D
Makes
25x75x50 20deg sloped front bin v6.stl 3d model
25x75x50 20deg sloped front bin v6.stl 3d model
25x75x50 20deg sloped front bin v6.stl 3d model
25x75x50 20deg sloped front bin v6.stl 3d model
This model is restricted by licensing terms. 

A very tight fitting snap-in bin for your Multiboard's push-fit (hex shaped) connectors. I made this quite snug so the first few times you go to take it out, you do have to wiggle it quite a bit. After a few insertions and removals, it gets a bit easier but still holds quite well.

There are 2 models: one is ~75mm wide, and the other is split in two (so you have 2 bins each ~37mm wide)

The bottom of the bin is filleted to make it easier to get little things out.

The push-fit-snap connector is based on https://thangs.com/designer/Keep%20Making/3d-model/Push-Fits%20-%20STL%20Multiboard%20Remixing%20Files-994668 to which I added an interference snap to the top, left and right sides.


3 Likes26 DownloadsJanuary 21, 2024
1


3 Likes26 DownloadsJanuary 21, 2024
This model is restricted by licensing terms.