THE SILENT PRINCESS FLOWER FROM ZELDA TEARS OF THE KINDGDOM

3D MODEL DESCRIPTION The Silent Princess Flower from Zelda Tears of the Kindgdom.

I've made this flower so that you can run wires through the stem and into the flower for lights if you want your flower to glow. The base is large enough to hide the battery pack (Two coin batteries). I've also created a hole in the side of the base so you can run a cord out the back if you want to plug the light in instead of running it off of batteries.

The bottom of the base has a cover that you can add magnets to hold the bottom on.

The Silent Princess Flower comes split up into: CombinedBase, Flower, JustBase, JustStem, and BaseCover. I've already added a brim to JustStem to help hold it on to the bed better as it's really tall and skinny.

Here's a link for the magnets I used:

https://www.amazon.com/gp/product/B09MVYGX1X/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1

and to the lights I used:

https://www.amazon.com/dp/B07CZCN21P?psc=1&ref=ppx_yo2ov_dt_b_product_details

Hope you enjoy!

I've put the whole creation process up on my Tiktok

https://www.tiktok.com/@stephsnerdystuff?_t=8jh9A2v0AVa&_r=1

3D PRINTING SETTINGS Settings I used to print this flower were:

3 walls 10% Infill 55 MM/Sec Print Speed Tree Support with 70 Degree Overhang Angle Brim

Approximate Print Time: 22 Hours Approximate Filament Usage: 120g or 40m

These could vary depending on your slicer, printer, and settings.