Bowden tube guard for Prusa frame edge

This guard slides snugly into place on the top edge of the Prusa's metal frame, to protect Bowden tubing from being damaged by sliding back and forth across the sharp edge.

For even more protection, apply a layer of masking or electrical tape on top of the guard to smooth out the surface. You can also sand it smooth if you wish.

The length fits within the brackets for my light bar kit, and can easily be scaled up or down depending on your print setup. Solidworks file is included in this model; you can use OnShape's free version to edit as needed.

3D printing recommendations:

• Print in PETG or another plastic that sands smooth easily
• Print with the flat top side against the print bed and the channel facing upward
• Position diagonally to fit on the MK3S print bed, or chop into segments and print in pieces
• Supports not necessary
• A brim may help with adhesion issues

If you like my work and want to support me, please check out my online store, become a patron, or buy me a coffee. Thank you!

This model is licensed under a non-commercial license. You may not sell prints of it, or redistribute the original file in any way. If you remix it, you must give attribution and share it under the same license.