This is a fully printed filament guide for the Ender 3 V2 with the Creality runout sensor kit installed. May fit other Ender-series printers as well, but I can't be sure. Clips onto the sensor's mounting bracket and the sensor itself to hold it securely in place. No extra hardware needed. The opening will fit a 4mm OD Bowden tube snugly. Depending on your printer's settings and capabilities, you may need to clean up the hole a little bit to slide the Bowden tube in.
I recommend printing at 99.99% infill in concentric pattern for maximum strength and time saving. Only took me about an hour.
Category:
0 Likes1 DownloadsJuly 24, 2024