Here i present NODES, my roll with decorative Junctions. These are not up to code anywhere and should only be used at low energy potential situations for their decorative values. The 50x50x15 variant free, the complete set with stacking backpacks is available for club members. I was in need for a small hub to route some power to LED's, then some more, so made some stacking brackets, i mean backpacks!
DISCLAIMER: NOT UP TO BUILDING CODE ANYWHERE IN THE WORLD (!USE PROPPER AND RATED JUNCTION BOXES!) There is a reason they are made from different materials - not water proof
Print orientation: see picture with suggested orientation
The fit is based on WAGO 221 fittings, but the bigger versions should work with others as well Cables sleeves available at 2mm->7mm but 9mm is possible (no sleeve) Parts need support expect for the base and backpack files
Printed in: PLA, Fiberlogy Easy grey, Graphite, and Copper
Designed for there decorative value, not practicality, use of support and efficiency where disregarded
Uses M3 (3x20mm) for attaching Upper→Lower
Uses M3 (3x25mm) for attaching Upper→Backpack→Upper
There are more practical designs from talented designers out there! You should check those out as well
Consider following me on Instagram (@SMACKMAX_). I try to post all of my prints, renders, and animations to build a portfolio of my projects, often in advance of publishing the models. This way, you can get a sneak peek of what's coming next! https://www.instagram.com/smackmax_/