Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:2922636.
It's a low poly chicken, what more could you want?
Thanks to dejavuus for the original.
This Chicken balances quite well on its own however the legs are very thin and you may want to add a disk for it to stand on to give it some more strength. I gave the legs 4 perimeters and 80% fill but I dropped it from about 500mm and one of the legs still snapped off. Glued it back on and it looks fine.
The main body I printed with 0% fill. If you aren't familiar with printing overhangs then you'll want to use a 10% fill as the back is quite flat in some areas. You'll see in the photo that the back on my print is quite thin. I think my print temp was 5 degrees too high to have 0 infill.
I used supports in some areas such as between the legs, under the tail and under the chin but you might be able to get away with not using them if you know what you are doing (I'm still new to printing).
You might want to scale this up as I did, it's pretty small.
Also, no I don't have a photo without the supports, I have already given this as a gift.