Say hello to Pandy — your roly-poly, chill little panda friend who just wants to hang out and snack on bamboo all day 🌿

• Print in place
• No support

🖨️ Print Profile

Layer Height: 0.08 - 0.2 mm (tested on 0.2 mm, but 0.16 mm or lower is recommended for best detail) Infill: 15% Gyroid Wall loops: 2 Supports: None required Scale: You can scale up freely. For smaller prints, keep scaling proportional and try lowering the Z height gradually—I tested it at 20mm Z scale and the joints still worked great!