the 1/4-20 thread in my rangefinder broke, and i am too lazy to warranty it. I modified an arca plate to mount on the screw hole for the belt clip on the right side. you will need 3x M4x8 screws, the stock ones don't fit. I would recommend printing with thick walls to increase rigidity. the rangefinder still fits in the case it comes with, but is not so ergonomic for hand holding. As I use it on a tripod so I can actually hold it on the intended target without my coffee induced jitters, this is not a problem for me.
PSA: drugs are bad kids, caffeine is a drug too.
the arca plate was Remixed from Joar's Arca-swiss plate at: https://www.printables.com/model/781218/files
Categories:
0 Likes1 DownloadsApril 6, 2024
0 Likes1 DownloadsApril 6, 2024