File link: https://makerworld.com/en/models/622109#profileId-546182

If you would like to sell my model prints, please subscribe to my commercial plan

these spiral or Christmas ornament earrings are fun and unique. You can add several to one earring, you can just have the one, or you can scale it up to make it more noticeable, either way it is sure to make a statement wherever you go.

One set has a loop on the top the other does not

NOTE: IT MUST BE PRINTED WITH SUPPORTS AND 0.3mm Z OFFSET TOP AND BOTTOM

Note: This may be a little rough on the bottom, but its crucial that you are delicate with it and its support removal, as it is fragile.

I've only ever used bambu basic, so I'm not too sure how it is with other filaments, but judging on every ones comments, not good. Just USE BAMBU BASIC

If you have trouble or do not like the rough bottom, then consider scaling the model up for better results.