Stackable Basic Planter
76 downloads · 3 years ago · I made this Planter because I needed a few and didn't want to go to the hardware store.
I would not
I made this Planter because I needed a few and didn't want to go to the hardware store. I would not recommend printing this in huge numbers, they are a looot cheaper to buy. Print in PETG or anything else UV resistant if you want them to last. The triangle holes at the side are for water. Normally, Pots sit on small ledges, but that would require an unnecessary amount of support filament. This way, water can still get inside. #OutdoorThangs
Stackable Basic Planter
76 downloads · 3 years ago in  andÂ
Whiplash Fidget Toy by Ruven Bals and Oskar van Deventer
Slime Ball Fidget Toy by Ruven Bals Print in Place
Orbifact Fidget Toy by Ruven Bals
Planetary Gear Cube Fidget Toy by Ruven Bals
Gear Ball Fidget Toy
Slime Ball 2.0 Fidget Toy Print in Place by Ruven Bals
Slime Egg Fidget Toy Print in Place by Ruven Bals
Tornado Tower Fidget Toy
Kinetic Vase
Auxetic Chess Print in Place by Ruven Bals
Jacobs Ladder Fidget Toy
Gear Fractal Fidget Toy
Twisty Chess Board by Ruven Bals
Sliced Pumpkin Box
Hinge Ball transforming Fidget Toy
Gear Tentacle Fidget Toy
Brain Gear Fidget Toy
Crystal Bloom Lamp for the Ceiling
Liquid Cat Fidget Toy Print in Place
