tracking pixel
Ruven B

Avocado Gear Ball Fidget Toy

by
RuvenBals
Follow
Follow
Remix Model
RuvenBals
RuvenBals
|
Image 1 of 4
Avocado Gear Ball Fidget Toy 3d model
RuvenBals
RuvenBals
|
Image 1 of 4
Avocado Gear Ball Fidget Toy 3d model
2D
3D
Makes
Avocado Gear Ball Fidget Toy 3d model
Avocado Gear Ball Fidget Toy 3d model
Avocado Gear Ball Fidget Toy 3d model
Avocado Gear Ball Fidget Toy 3d model
This model is restricted by licensing terms. 

This is a collaboration with Gazzaladra check out his stuff here: https://thangs.com/designer/gazzaladra

You need: All 14 Pieces 1 heart 14 Connectors

You can also just print the "All" File. Everything you need is in there.

Print settings: Use a Brim. Apart from that, you can go with your standard settings.

Assembly: I made a Video how to put this together here. All gears have a number and direction that corresponds with the number on the heart surfaces. The bigger gears have them in actual numbers on the bottom. The direction of the numbers on the heart matches the direction of the numbers on the gears. The smaller gears have several indentations on the side. The number of these correspond with the number on the heart. One of the indentations is bigger than the others on each small gear. This bigger indentation must point towards the corresponding number on the heart. Insert all connectors into the heart. Insert gear number 4 Insert gear number 14 next. These two have the part where the avocado was attached to the tree on them. By keeping those two in the right rotation while assembling the rest reduces the chances for errors.

Troubleshooting: You can watch this Video https://youtu.be/fEXfZhAPBgY Gears skipping: I had a problem with the Gears skipping and getting stuck when I used different filaments for the Gears and the Heart. Try using the same filament for both. If that dost help scale the Heart a little smaller or the gears a little Bigger.

Connectors Break: Print them solid. 100% infill or enough walls. Maybe scale them if they happen to be too big for the holes.


23 Likes117 DownloadsSeptember 12, 2024


23 Likes117 DownloadsSeptember 12, 2024
This model is restricted by licensing terms. 

Instructions

Filament • 0.2mm

MaterialPLA
Layer height0.2 mm
Infill density10 %
SupportsNone
BrimYes