tracking pixel
Chris W

Retro TV Spider-Man Cartridge

by
RetroMaker
Follow
Follow
Remix Model
RetroMaker
RetroMaker
|
Image 3 of 3
Retro TV Spider-Man Cartridge 3d model
RetroMaker
RetroMaker
|
Image 3 of 3
Retro TV Spider-Man Cartridge 3d model
2D
3D
Makes
Retro TV Spider-Man Cartridge 3d model
Retro TV Spider-Man Cartridge 3d model
Retro TV Spider-Man Cartridge 3d model
This model is restricted by licensing terms. 

The RetroMaker TV Spider-Man Cartridge can be inserted into the Retro TV 1967 (https://social.thangs.com/m/639400). This is a 5 color (black, white, grey, red, blue) print with a couple of filament swaps for line details. Info on setting up a Filament swap (link to come) . Assembly takes about a half an hour and consists of trimming and sanding the color pieces so they fit well, I use a razor knife to scrape edges and to push the pieces into place. This depends a lot on how much elephant footing occurs with each filament and your settings. I suggest a low bed temp.

Spidey Blue - .2 layer height print with blue. Enter a filament swap in your code at layer 11 and then switch to black. Filaments shown Eryone Matte Aqua Blue PLA - Tianese Black PLA

Spidey Red- .2 layer height with red. Enter a filament swap in your code at layer 11 and then switch to black. Filaments shown - Tianese Red PLA - Tianese Black PLA

Spidey White - Filament shown - Overture Matte White PLA

Spidey City - Background - I use 12% gyroid infill. Filament shown - Eryone Metallic Wolfram PLA

Spidey Silk - Print at least 8 pieces, use tweezers and a tool to push in place (it can be difficult, trim any hairs or edges). Filament Shown - Eryone Metallic Wolfram PLA

Spidey Blk - Cartridge , No supports, I use 12% gyroid infill. Filament Shown - Tianese Black PLA

Creative Commons License BY-NC-ND 4.0 No derivatives, no commercial use and please share attribution when posting to social media.


45 Likes25 DownloadsJanuary 20, 2023


45 Likes25 DownloadsJanuary 20, 2023
This model is restricted by licensing terms.