Go back in time with this 1938 radio case for a bluetooth speaker. With this small, nostalgic retro version of a classic radio you can enjoy listening to old radios shows, music from then or really any era. Can also be used without the speaker for a decorative stash box to hold fun items. The knobs even twist for fidgeting fun.
This version in sized for an Altec-Lansing Mini H2O bluetooth speaker which you can get here on Amazon.
The box and lid print seperately and are both 2 color, AMS or color swapped prints (which won't exactly match the pictures, the box will have more strips). Both knobs are printed separately (no supports) and snap in place to the lid. I would recommend NOT using silk pla for the knobs as they tend to snap and break.
Print Instructions:
-
Box prints without supports, make sure you have good plate adhesion for the corners of this box. Use the .3MF AMS file or manually color swap the stripes layers: 10.0mm-13.0mm 16.4mm-19.4mm 22.8mm-25.8mm
-
Lid requires normal supports and a color swap for the speaker grill between layers 4.2mm-4.8mm. 20% Infill Recommended. Supports and support interface can be difficult to remove. Be gentle snipping the support interface from the grill to not damage it. Make sure to fully remove supports around the edge so the lid will fit on the box, it is a snug fit which will loosen up over time.
-
Knob1 requires an AMS system to get the logo flush on the dial. No supports. 3 walls 30% infill.
-
Knob1thick is a version to print if your filament shrinks the peg and is too loose. 3 walls 30% infill.
-
Knob1swap is designed to swap colors between layers 0.6mm -1.0mm.3 walls 30% infill.
-
Knob2 is one color, no supports. 3 walls 30% infill.
-
Knob2thick is a version to print if your filament shrinks the peg and is too loose. 3 walls 30% infill.
Creative Commons Licenses 4.0 BY-NC-ND - Attribution, Non-Commercial, No Derivitives. A commercial license to sell these prints any many others is available by subscribing to my Thangs Commercial Partner membership plan.