tracking pixel
RetiredGuru

Dell Wyse Dx0D Thin Cient Accessories Holder

by
RetiredGuru
Follow
Follow
Remix Model
RetiredGuru
RetiredGuru
|
Image 1 of 7
Dell Wyse Dx0D Thin Cient Accessories Holder 3d model
RetiredGuru
RetiredGuru
|
Image 1 of 7
Dell Wyse Dx0D Thin Cient Accessories Holder 3d model
2D
3D
Makes
Dell Wyse Dx0D Thin Cient Accessories Holder 3d model
Dell Wyse Dx0D Thin Cient Accessories Holder 3d model
Dell Wyse Dx0D Thin Cient Accessories Holder 3d model
Dell Wyse Dx0D Thin Cient Accessories Holder 3d model
Dell Wyse Dx0D Thin Cient Accessories Holder 3d model
Dell Wyse Dx0D Thin Cient Accessories Holder 3d model
Dell Wyse Dx0D Thin Cient Accessories Holder 3d model

I picked up a Wyse think client to use as an alternative to a Raspberry Pi for running OctoPrint. Until I was sure I this device would meet my needs, I used only components I already had: a 4 GB SoDIMM to replace the 2 GB unit within, an external HDD, a D-Link USB 2.0 powered hub, and a Logitech webcam. Everything worked well, but I needed a smaller footprint for where this ensemble would be put to work.

This holder is designed to straddle the device with the dimensions of the external HDD and USB hub in mind. I've included the STEP file to allow for dimension change for your accessories.

Resolution: 0.2 mm Infill: 15% Walls/Perimeters: 4 Support: Brim recommended Filament: PETG, ABS, ASA, Nylon

Print on its side. If you have any doubts on bed adhesion add a brim or use tabs on corners. The STEP file is included to adjust dimension for your particular accessories.


1 Likes5 DownloadsJuly 7, 2022


1 Likes5 DownloadsJuly 7, 2022