This is a set of twenty-four bomber plane pegs compatible with Wings of Glory bomber flight stands. Note that these pegs are bigger than the normal plane pegs (which are also available). These are not the flight/altitude pegs -- these pegs (or posts) are meant to be permanently attached to the bottom of a plane model. On the diagram in the gallery is marked red Sprue (waste), blue lead-in, and green pegs. To use these:

1. Drill a roughly 1.5mm diameter hole (or slightly larger) in the bottom of the plane near its center of gravity, near the balance point of front-vs-back.
2. Separate the lead-in and peg from the sprue and then trim the lead-in length to match the depth of the hole you drilled, or slightly shorter.
3. Dry-fit the lead-in and peg.
4. If the fit is good, you can take it apart and add some glue to the lead-in before re-inserting, to make the peg permanent.

There is also a flanged version of the bomber peg that does not require drilling (though the joint may be of lower strength).