Wendy D
RebelAlicornDesigns2.1K followers
Follow
RebelAlicornDesigns
RebelAlicornDesigns
|
Image 1 of 5
Fairy Turtle 3d model
RebelAlicornDesigns
RebelAlicornDesigns
|
Image 1 of 5
Fairy Turtle 3d model
Fairy Turtle 3d model
Fairy Turtle 3d model
Fairy Turtle 3d model
Fairy Turtle 3d model
Fairy Turtle 3d model

Fairy Turtle

Purchase model for $5.99 USD
This model is restricted by licensing terms. 

In a glimmer-glow grove where the soft breezes swirled, Lived a fairy turtle named Twilla Twirl.

With a shell holding sachets tied snug, Both held dust with a magical glow.

When whispers went whooo, and shadows crept near, Bringing small bumps of worry and fear,

Twilla would wiggle, then puff up with might, “I sprinkle my sparkles, now off with you, shoo!”

With a toss and a twirl, poofity-poof-puff! The spirits would fade and vanish in a flash.

The forest grew cozy, the dreams soft and bright, All thanks to Twilla Twirl every night.

** NOTE ** You need to update your Bambu slicer for the Spectrum Color 3MF to work. I would do a full plate, add purge objects to limit the amount of purge this file creates with a printer like the X1C, P1S, A1, etc.

This file will transfer to an updated version of Snapmaker's slicer, but the results will be different.

Layer heights affect the gradient as well. I did a .16. The smaller the layer height, the better the effect of the transition.

Filaments Used: Protopasta: Unicorn Tears, Night Before Blue, Dragonfruit Smoothie, Electric Lemonade

Utilize basic - white, dark blue, yellow, and hot pink to achieve close to the same gradients.

Join the Discord; it is my main source of communication and the easiest way to provide help when needed.

PLEASE READ: All Rebel Alicorn Designs are protected under copyright. This purchase is for personal use only. Digital files may not be shared, resold, remixed, or redistributed in any form. Selling physical prints is not permitted without authorization. To sell PHYSICAL PRINTS, you must join the Merchant Tier on Patreon, Thangs, or MMF Tribe. Merchant members receive exclusive designs and discounts on past files.

Printing Recommendations: Initial layer and initial fill: 25 mm/s Layer Height: 0.20 mm Walls: 3 Infill: 15%

Safety Warning: These designs are not suitable for unsupervised play by children or pets. Broken or rough-played 3D prints may produce sharp edges or small parts that can pose a choking hazard; not recommended for children under the age of 5.


Discussions

Fairy Turtle

45 downloads · 1 month ago in  and 
Wendy D
RebelAlicornDesigns2.1K followers
Follow
Purchase model for $5.99 USD
This model is restricted by licensing terms.