Hey rock star you just found my best selling desk organizer! I print these in PLA with zero supports and 15% infill. There is a little bit of cleanup required in battery compartment and along the recessed dips for the light installation. I used a 4 ounce glass jar to hold IPA, standard sized wax pucks and a 5" x 4" silicone wax pad. It is up to you if you want to sell the organizers with these items included. The light is important, (Link below) to install the light push the end through the battery compartment and pull the wire through the top hole. Once you have a good amount of wire start shoving it into the recessed light track, starting at the center of the spiral and follow it along. There will be extra wire that will stay in the battery compartment area. When you buy the lights, remove the clip with a phillips screwdriver so it will fit in the compartment. I use a blunt end of the screwdriver handle or other tools to shove the wire into the track throughout the model. These trays look amazing in rainbow, glitter and glow filaments.
https://www.amazon.com/dp/B08L8ZL5K9?psc=1&ref=ppx_yo2ov_dt_b_product_details
COMMERCIAL LICENSE - With your active support to Rytek through this Thangs membership you have a commercial license to legally sell 3D prints of my designs on any online platform or physical store or booth of your choice. You must be the one printing the files as the file is not to be shared. All digital files are NOT to be resold or redistributed by any means. - This commercial license is only valid during your active Thangs Membership support. If you decide to no longer support my Thangs account the commercial license will end at the time your paid access expires.
Recommended Printing settings - 0.4mm Nozzle Printing at 0.20mm Standard settings in bambu Studio Filament type: PLA Infill % : 20% Infill Pattern: Gyroid Supports: NO (May want to try minimum ones in the battery compartment. Brim: No Raft: N0 Skirt: No