Great Scott! Print your own Mr. Fusion Reactor prop that's also a dice tower!
Gloop and Protopasta merged together to form a special collab for the February Endless PLA Subscription!
Learn more about this collab here: Gloop x Protopasta
Want this model a month early and/or sell this design? Become an Endless Designs Subscriber here: Endless Designs Subscription
Print Settings -.2mm Layer Height -15-25% infill -The Mr. Fusion Base top is a 3mf if you want to print with color -Supports Needed for Lever -Supports optional for bolt holes on the base bottom and top
Assembly -Print all parts -Secure the lever onto the front of the base -Secure the Top to the Bottom using the 10mm nut and bolt -Slide the container into place of the base top -Gently pressure fit the knob onto the back -I found that heating it a bit with a lighter helps because it will want to snap if you press too hard -Press the lid onto the top -Some sanding may be necessary due to printer tolerances