Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:5364340.
NOTE: THIS JUST ADDS TWO ADDITIONAL FILES. YOU WILL STILL NEED TO PRINT OUT THE ORIGINAL WEARABLE ARC REACTOR.
The original model this was remixed from can be found here: https://www.thingiverse.com/thing:32274
Step 1: Buy "El Wire 5 Pack, 9ft Neon Light with Battery Pack (Red, Blue, Pink, Green, White)" by Kalakila and "Submersible LED Lights" by SHYMERY on Amazon. They should cost $16 and $13 dollars respectively.
Step 2: Print all the parts of "Wearable Arc Reactor" except for the Crystal and Ring1. You won't need those two parts. Important: Print Ring2 at 95% size. It needs to be a bit smaller to make it easy to twist.
OPTIONAL: Print this instead of the normal top piece: https://www.thingiverse.com/thing:5346928 This allow you to make the coils red instead of silver.
Step 3: Print the two LED holders from this design
Step 4: Assemble the wearable arc reactor like normal.
Step 5: Glue LED_Holder3 to Ring2. Remember Ring2 needs to be printed at 95%.
Step 6: Put both parts of the LED holder on one of the LED lights. They should fit just right. Add some tape if you need the fit to be a bit tighter.
Step 6: Put some glue on the bottom of the LED holder and pace it in the middle of the Arc Reactor. Take you time and center it as best as you can.
Step 7: Feed the EL Wire through the hole into the base. You may need to make the hole a bit bigger. Coil it around the inside of the base. You may need disassemble the wearable arc reactor to do this.
Done. You can turn on the center LED on by twisting it. The EL wire has a button on the battery box.