PRIVATE USE ONLY⚠️

Hi I'm Kelly! 👋 I'm a dog mom and aspiring 3D designer! These files are my intellectual property and the files CANNOT be shared, remixed or sold in any way. A Commercial License is Required to legally sell physical prints of my designs. 👉HERE is a link to my commercial license options!

DESIGN DESCRIPTION🌷🌷🌷

Soooo.... as I mentioned, I went a little overboard with flowers! When I started asking around what flowers would make fun clickers, tulips were a pretty consistent answer, but they didn't really fit with the flowers in a pot that I had been working on. I obviously decided to make them anyway, they just get their own day!

The caps are raised, which I felt was the only way to really get the detailed, textured look I was hoping for and I really like how they turned out. This design includes a single clicker tulip and a tri-clicker tulip for additional options! I don't know about you, but there is something I find so enjoyable about multiple clickers in one! 🌷

CLICKER INFORMATIONℹ️

Like most of my designs, this is a clicky design that requires a mechanical keyboard switch to make the clicky part. These models feature a universal base design which has been tested with many keyboard switches and 99% of them work! I have an up to date list of verified clickers with links you can find HERE. This design should be compatible with most MX style keyboard switches, however, the two metal contacts on the bottom of the switch must be clipped off flush (or folded over) to ensure the switch seats properly in the base (this is a destructive process).

This pack contains one cap design and 2 base designs. The tri-clicker base design offers two options, one with a 25mm (1 inch) binder ring and the second blank with no hole. The single clicker base is provided with the standard keychain configurations, none, 7mm and 3.5 diameter ring.

LICENSING⚠️

This is a PRIVATE USE ONLY license.

Commercial License options available 👉HERE

Sharing, sub-licensing, selling, renting, hosting, transferring, distributing, modifying, or remixing of any of the digital files contained in this design is NOT ALLOWED.

3D PRINT SETTINGS⚙️

Layer Height: 0.2mm (recommended) External Perimeter: 0.33mm (recommended) Scale: 100% (Everything is modeled with tight tolerances and should not need to be resized) Orientation: Orientation: Print the caps face up

⚠️WARNING⚠️ - This pack requires very good bed adhesion to ensure the best possible results for your finished clicker. It is recommended to clean your bed with soap and water before printing or whatever your specific printer manufacturer recommends for a deep bed clean!

Stay Pawsitive! 🐾

For model help or other questions, please contact us at support@pawpularprints.com