Food Can Dispenser - Stackable FIFO System - 5 can size
byOlo DeepdelverFollow
Follow
Remix Model
Social
This model is restricted by licensing terms.
View license.
10 Likes11 DownloadsDecember 2, 2022
This model is restricted by licensing terms.
View license.
Model has been moved to Printables.com:
Organisation freaks: You need it! Preppers: You need it even more!
Couldn't find a proper FIFO (first in first out) system on internet, now there is one !
Design:
- Fully Stackable system
- Should fit all type of cupboard !
- Mix/modulate parts as desired
Print:
- @10%
- 2 perimeters
- 0.3layer heights.
- No support
It is strong enough, more would be a waste of time/plastic
Assemble:
- Stack as desired !
- Used some small screws to fix everything together, i'm sure you'll have what what is needed ! I used 10mm_D2.5mm cheap screws on my v2 (check picture for exact measurements)
Available files:
So far I generated all the files for these 5 different can sizes.
CAN_D\CAN_H CAN Height 35mm CAN Height 40mm CAN Height 42mm ** CAN Height 66mm** ** CAN Height 86mm** MIDDLE tubes Feets D54.5mm - - Yes Yes Yes Yes, 6 sizes Yes, 2 types D67.2mm Yes Yes - - - Yes, 6 sizes Yes, 2 typesIf you have different diameters/height, message me i'll try to generate the files for you and add them here (try).
Hope it helps !!!
Note:
- It only works for cans that have the same diameter on both side.
- I added some measurement
10 Likes11 DownloadsDecember 2, 2022
This model is restricted by licensing terms.
View license.
10 Likes11 DownloadsDecember 2, 2022
This model is restricted by licensing terms.
View license.