This a Re-Mix on STENMIC creation for the Anycubic Vyper. This a foot that slides into the rails and it secures it self in the channels. The original didn't work for me and what I needed. Thank you Stenmic for this creation. 

This will need an M4 heat press insert so that the original rubber damper will screw into it. (please see images) 

Vyper Foot Re-Mix V2.stl

This a Re-Mix on STENMIC creation for the Anycubic Vyper. This a foot that slides into the rails and it secures it self in the channels. The original didn't work for me and what I needed. Thank you Stenmic for this creation. 

This a re-mix of the PTFE Suport from JayBee Doge. This re-mix has a little better fitment for my Vypers.

Vyper PTFE Support.stl

*UPDATE*
I modified the cooling ducts to direct the air more toward the nozzle exit so that the filament cools better (better air flow)

Hello all this is a V2 remix of the Satsana for the Ender 3. I remixed it to fit my CR10S and added an air duct to take a 4020 fan. I also fitted space for an LED bar. This set up can fit your printer without the MicroSwiss kit but for my purposes it works fantastic with it.
There is no need to update firmware with this just re-leveling your bed and you are all set. 
**Printed on my CR10S**
- Sunlu Petg
- Speed 30mm
- Nozzle 220c
- Bed 75c
- Quality 0.2
- Supports Yes (minimal please take a look at the included pictures for support placing)

Took a little long to print but i was going for a bit more quality than speed.

This will print well with PLA+ but if you’re going to print long prints (15hrs+) ducts might get soft and deform.

Here is the link to the LED kit I used

https://printermods.com/products/led-lighting-kit-for-3d-printers-hot-end-version

Link to the 4020 fans I used 

WINSINN 40mm Fan 24V, 3D Printer... https://www.amazon.com/dp/B07L3CT33J?ref=ppx_pop_mob_ap_share

CR10s Hotend CoolerV2.stl

Hello all this is a remix of the Satsana for the Ender 3. I remixed it to fit my CR10S and added an air duct to take a 4020 fan and an LED bar. This set up can fit your printer without the MicroSwiss kit but for my purposes it works fantastic with it.
There is no need to update firmware with this just re -leveling your bed and you are all set. 

CR10s Hotend Cooler.stl

Activity related to collaborating with others on models

Likes, comments, and activity from your community

A roundup of models that we think you'll like

For when we think someone might have posted your content as their own

New content from your premium memberships

Emails and messages from designers you follow

Ohio_Inspire

Achievements

Novice Maker

Seedling

Voyager

Vyper Foot Re-Mix V2.stl

Vyper PTFE Support.stl

CR10s Hotend CoolerV2.stl