tracking pixel
O

CR10s Hotend CoolerV2.stl

by
Ohio_Inspire
Follow
Follow
Remix Model
O
Ohio_Inspire
|
Image 6 of 10
CR10s Hotend CoolerV2.stl 3d model
O
Ohio_Inspire
|
Image 6 of 10
CR10s Hotend CoolerV2.stl 3d model
2D
3D
Makes
CR10s Hotend CoolerV2.stl 3d model
CR10s Hotend CoolerV2.stl 3d model
CR10s Hotend CoolerV2.stl 3d model
CR10s Hotend CoolerV2.stl 3d model
CR10s Hotend CoolerV2.stl 3d model
CR10s Hotend CoolerV2.stl 3d model
CR10s Hotend CoolerV2.stl 3d model
CR10s Hotend CoolerV2.stl 3d model
CR10s Hotend CoolerV2.stl 3d model
CR10s Hotend CoolerV2.stl 3d model
This model is restricted by licensing terms. 

UPDATE I modified the cooling ducts to direct the air more toward the nozzle exit so that the filament cools better (better air flow)

Hello all this is a V2 remix of the Satsana for the Ender 3. I remixed it to fit my CR10S and added an air duct to take a 4020 fan. I also fitted space for an LED bar. This set up can fit your printer without the MicroSwiss kit but for my purposes it works fantastic with it. There is no need to update firmware with this just re-leveling your bed and you are all set. Printed on my CR10S

  • Sunlu Petg
  • Speed 30mm
  • Nozzle 220c
  • Bed 75c
  • Quality 0.2
  • Supports Yes (minimal please take a look at the included pictures for support placing)

Took a little long to print but i was going for a bit more quality than speed.

This will print well with PLA+ but if you’re going to print long prints (15hrs+) ducts might get soft and deform.

Here is the link to the LED kit I used

https://printermods.com/products/led-lighting-kit-for-3d-printers-hot-end-version

Link to the 4020 fans I used

WINSINN 40mm Fan 24V, 3D Printer... https://www.amazon.com/dp/B07L3CT33J?ref=ppx_pop_mob_ap_share


4 Likes37 DownloadsAugust 30, 2022


4 Likes37 DownloadsAugust 30, 2022
This model is restricted by licensing terms.