5 Drawer Solid Feet

I printed mine out of PETG but PLA will work fine.
But this I made these feet to replace the casters on my 5 Drawer Organizer I got from Amazon. I didn't want it rolling around my space and I didn't want it on the floor, and nobody else seems to have made feet for these yet. Or I can't find any. lol.
I believe these set the drawers at about the same height as if it had the casters and I'm almost positive I used the factory screws. Can't remember to be honest. But they work and that's all that matters.

ENJOY.....!!! :)

Phone Mount Toyota Camry S20FE Samsung

Hope someone can use this model. 
It is inspired by another model on T.V. but I can't remember the user or model. 
Either way this is a mount for a Samsung S20FE 5G.  It mounts your phone sideways on the dash.  And it has enough room in it to hold a phone that's inside a case.  The case I used is 3D printed but I'm sure others will fit as well.  And I put a hex pattern on it cuz i thought it looked kinda cool. haha...! 

This is printed in PETG but you can use whatever material you would like.  Just keep in mind that PLA has a low glass transition temp and could possibly deform in extreme heat. PETG isn't perfect but it's a little better. 

**NOTE: This will most likely fit other cars and phones, but I have not tested any. **

Either way I hope someone can use this. 
This is my first upload here so be sure to check out my other models. 

Just someone who makes a few models on the computer and feels that others may enjoy/use them.
So I hope you guys enjoy...!!!

NuahS912

Achievements

Seedling

5 Drawer Solid Feet

Phone Mount Toyota Camry S20FE Samsung